Sliding Doors

1 / 2


At the very beginning, any fitting runs nice and smooth. A good installer cleans the running surface of the track and the rolls of the carriages. Dust and slight dirt accumulate again after a short time, however, for example due to the abrasion of the rollers inside the running track. This can be prevented easily though. But once the dirt sticks to the rollers, this can turn into a problem. They don´t run smoothly any more and moving the sliding door feels like driving on a gravel road. Our innovative system therefore cleans itself. The brushes on the front and rear of our “self-cleaning carriage” keep everything clean. In this way, the movements of the door seem like its maiden voyage, even after many years – it´ll run even longer than Forrest Gump. 12 |

2 / 2


Things should work quickly and easily. That´s why we have revolutionised the installation of Soft-Close. We have combined activator and stopper into one single component, the “active stopper”. So, no need to mount both parts separately any more. But what is even better: Looking for the right installation position of both parts is no longer required either: We have simply included the right position as a fixed installation. In addition, you don´t need to remember any longer to install the damper “pre-tensioned”. Everything is already done – and that´s “simply onlevelicious”.

Oh yes, we´re kicking up our heels again and the walls start to crumble. Not because Forrest Gump paid us a visit but because INFINITYSLIDE is that cool that even the surrounding dirt bows in deference. That is why we have put off everything else just to present this sliding door to you. INFINITYSLIDE can be mounted that simply and intuitively that you can have a cushy number and could easily watch the Forrest Gump movie in the meantime.

Discover the possibilities

and check out our Webshop
Go to webshop

Handy downloads and documents




InfinitySlide Glass Door

Mounting Instruction


InfinitySlide Wooden Door

Mounting Instruction


Frequently asked questions

Where can I find the installation instructions?

Probably everyone has lost mounting instructions. You can find our mounting instructions not only on our website but also printed into the FLEXFIT boxes.

How are the profile packaged?

We pay special attention to packaging. All visible surfaces are protected by a film. Additionally, the profile is packed in a sturdy box.

Are your systems tested?

All the products we supply are tested in accordance with the governing standard.

How does ONLEVEL address the problem of drainage?

All profiles have drainage holes through which any water entering the profile can drain off. We recommend surface mounting onto a sealing/drainage layer. However, if you use chemical anchors, sealing problems belong to the past. In addition, very little water enters our profiles as the rubber seals are only subject to very small load differences. Thanks to the FLEXFIT technology, the pivot point is in an optimum position.